This is a generated file for the l3build validation system.
Don't change this file in any respect.
PASS: block hook overrides built-in width
PASS: local options override hook
PASS: hook does not leak from picture
PASS: default block height is 1cm
PASS: default pulley diameter is 1cm
PASS: zero spring leads compile
PASS: descending contact starts at top x
PASS: descending contact starts at top y
PASS: descending contact ends at br x
PASS: descending contact ends at br y
PASS: contact agrees with slope midpoint x
PASS: contact agrees with slope midpoint y
PASS: top left contact midpoint x
PASS: top left contact midpoint y
PASS: top right contact midpoint x
PASS: top right contact midpoint y
PASS: normal perpendicular to tangent
PASS: prism centroid uses resolved height
PASS: prism left face midpoint
PASS: prism exit midpoint alias x
PASS: prism exit midpoint alias y
LaTeX Font Info:    External font `cmex10' loaded for size
(Font)              <7> on input line ....
LaTeX Font Info:    External font `cmex10' loaded for size
(Font)              <5> on input line ....
ROUTE: 1/2
PASS: helper honours local line width
PASS: scope route start preserved
PASS: scope route end preserved
PASS: pendulum zero angle x
PASS: pendulum centre-to-centre length
PASS: support size reaches base
ANCHORS: enabled
KEYS: enabled
KEYS: keys-only
ANCHORS: anchors-only
ANCHORS: local
ANCHORS: prefix-named
KEYS: prefix-named
PASS: local debug colour saved with prefixed name